![]() Without a doubt, a homemade signal repeater will help us to improve the internet of our WiFi router to play online, connect in videoconferences, watch videos more fluently and will facilitate many other things that we have to do on the internet.While more difficult to construct than the previous two, a circularly polarized antenna allows you to communicate with linearly polarized antennas oriented vertically or horizontally (just watch out for nulls). In this way we will prevent third parties with bad intentions from having easy access to Wi-Fi. On the other hand, it is important to note that with this method you will be able to reduce interference and protect the router from computer attacks.The ideal is to put this sheet lying on a wall or fixed to it to be able to redirect the Wi-Fi signal to areas within our department where the signal was previously very weak. Once the glue has dried, you will only have to place this aluminum sheet right behind the antenna of your router.In this case you will have to glue the paper to the cardboard with liquid glue or with a little adhesive tape. To continue, you must completely cover the cardboard that you just cut with the aluminum foil. ![]() To start you will have to carefully cut a cardboard the size of a common letter sheet.Without a doubt, this other method to make a home Wi-Fi signal repeater is also quite simple and also does not require special materials, since everyone has aluminum foil in their homes. Now, in this new section we will take the trouble to explain in depth everything you need to do to be able to amplify your Wi-Fi signal with aluminum foil. Using aluminum foil to improve the signal of your router To finish you have to direct the wifi antenna towards the direction in which you want the router signal to be amplified.Then you can use some adhesive tape to fix this satellite dish to the wifi.In this step you will only have to pass the wifi antenna through the hole at the base of the repeater that we have made with the can.In this way we have already completed our wifi antenna repeater.Now the top of the can will serve as a support or base for the rest of the antenna.Subsequently, you must cut in a straight line from the bottom to the top of the can, going through the middle of it to create a kind of satellite dish.Remember to leave a piece of can so that the top stays attached to the rest of the can. Unlike the bottom of the can, the top should not be cut off in its entirety.The idea is to cut the lower part like the upper part. To start you should look for a beer can and a utility knife, however you can also use scissors.That is why we invite you to follow the following instructions to the letter so that you do not have problems to make a home Wi-Fi signal repeater with a can of beer and thus improve your Wi-Fi signal at home. ![]() In this way you can direct the signal so that it can reach places that are far from Wi-Fi. This method is quite simple to carry out because you will only need a can of beer to improve the internet signal in your home.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |